Setup:

• STEP 1: Start with a clean Paper Disc on the Turntable, secured with the Outer Ring, and positioned on the HypnoGraph Base.
• STEP 2: Place the 44 Gear in the bottom right slot of the HypnoGraph Base. Be sure the Gear connects with the Turntable Gear. Secure a Gear Spindle with the Spindle Tightener tool.
• STEP 3: Place the Gear Crank Handle in the center hole of the 44 Gear. Turn the Gear to make sure the Turntable Gear spins smoothly.
• STEP 4: Place the 42 Gear in the top right slot of the HypnoGraph Base, connecting the teeth with the Turntable. Secure a Gear Spindle with the Spindle Tightener tool.
• STEP 5: Place the T-Arm-to-Gear connector in the center hole on the 42 Gear.
• STEP 6: Turn the connector to be sure that the parts are aligned.
• STEP 7: Place the 47 Gear on the left side of the HypnoGraph Base, in the top slot. Slide the Gear to connect it with the Turntable Gear then secure a Gear Spindle with the Spindle Tightener tool.
• STEP 8: Place the T-Arm-to-Gear connector in the first hole of the 47 Gear and spin the Gear to test.
• STEP 9: Assemble the Pen Holder and T-Arm, with the T-Arm numbers towards the bottom. Secure the Pen Holder positioned at the number 6 and the T-Arm at 12.
• STEP 10: Attach the T-Arm to the Connectors positioning the T-Arm with the 47 Gear as the Sliding Gear.
• STEP 11: When the setup is complete, click the pen and turn the Gear Crank Handle to draw a beautiful 10-loop design.